Advertisement
Available languages
Available languages
Regulating Steam
7
The amount of steam can be regulated by
sliding the Steam Control on top of the Steam
Gun. Move forward to increase steam – backward
to reduce steam.
IMPORTANT: When the Steam Cleaner has run out of water,
steam, output will cease. Follow refill instructions (page 12)
to use your Steam Cleaner again.
Attaching Shoulder Strap
8
Using the detachable Shoulder Strap allows for greater freedom of
movement when both hands are needed for cleaning tasks.
To attach Shoulder Strap to the Steam Cleaner,
simply snap Shoulder Strap hooks on the
connecting rings found on unit.
When using Steam Cleaner with the Shoulder
Strap, avoid rocking or tilting the unit excessively
as this may cause water to enter the hose and
be discharged along with the steam.
CAUTION: We recommend testing the weight of the
Steam Cleaner before using it with the Shoulder
Strap. This is to prevent potential injury and ensure
it is not too heavy for you to carry comfortably.
Usage Suggestions
9
• For vertical surfaces, always wipe excess water from the top
down. This catches dirty water before it drips on clean surfaces.
• Avoid changing attachments back and forth while cleaning.
• Start with the smallest brush to clean tight spots and corners first.
• Wipe dirt as soon as possible, otherwise it will dry and re-adhere
to the surface.
Wood, Vinyl and Marble Floors
Use the Floor Brush with Cotton
Cloth attached. Move Brush across
floor as if you are mopping. When
Cloth is soiled, turn it over or replace
it with a clean Cloth. If you are wor-
king on a very dirty area, move the
Brush over the area slowly, several
times. If it is a wood floor, move
quicky to avoid heat or moisture
buildup in the wood.
NOTE: Unsealed wood floors i.e.,
un-painted or unvarnished wood
should not be steam cleaned.
To Strip off Floor Wax: Use Floor
Brush for open areas and Nylon
Detail Brush for corners or tight
areas - no Cloth, slow strokes. Work
a small area at a time, removing
the floor wax from the floor. When
all wax has been stripped, imme-
diately clean floor and brushes
with water before residue hardens.
Go back over stripped area with
Floor Brush (with Cloth attached)
to remove any remaining residue
before re-polishing.
Continued on next page
Using Your Steam Cleaner
9
Advertisement
