Advertisement
Available languages
Available languages
Filling Steam Cleaner with Water
3
WARNINGS
Carefully read all instructions before removing Boiler Cap.
•
Always unplug appliance and be sure it has cooled
•
completely before filling the Boiler.
*IMPORTANT*
Use tap water – distilled or demineralized water if tap water is too
hard. DO NOT add detergents, perfumes, oils or other chemical
substances.
Follow these instructions to avoid overfilling the Boiler.
• Be sure appliance is unplugged, and has cooled for at least 10
minutes before filling with water.
• Carefully remove Boiler Cap by
turning it counterclockwise.
• Pour in a maximum of 1.2 L/2 pints
water using the provided Filler Funnel.
Make sure that water does not overflow.
• Replace Boiler Cap by turning it clockwise.
• Plug unit into 3-prong, grounded outlet.
• Power Indicator Light will illuminate, unit will
produce steam and water tank will become
pressurized. If using cold water, heating time
is about 5 minutes. Using hot water reduces
heat time.
NOTE: Never turn on Steam Cleaner if Boiler is empty.
Connecting Extension Tube(s)
4
• Attach one Extension Tube to Steam Gun on Flexible Steam Hose.
• To attach Extension Tubes together, press down the locking button
while sliding Tubes together. Be sure button and hole line up and
button locks in place. To disconnect, press the locking button and
pull the two sections apart.
WARNING: Always ensure appliance is shut off and not steaming
when attaching an accessory to the unit.
Before Use & Using Your Steam Cleaner
Max. 1.2l
7
Advertisement
