Monster SC60 HSD Instruction Manual page 17

D. Wall Bracket – Installation
*IMPORTANT*
The Tool Caddy MUST be installed on the Steamer before the Wall
Bracket can be used.
WARNING!
When storing the SC60 Steam Cleaner on the Wall Bracket, ensure
that any tools on the Tool Caddy are not in a dangerous position.
Example: Extension Tubes could be a hazard if the rack is mounted
at eye level.
The Wall Bracket can be permanently mounted to a wall or inside a
cupboard or closet. Slots on the underside of the Tool Caddy slide
easily on to hooks on the Wall Bracket, giving you convenient off-
the-floor storage.
Before attaching Wall Bracket, be sure that...
– there is enough room to accommodate the Steamer and Tool
Caddy with tools attached
– there is at least 2.5"/6.5 cm clearance ABOVE where Bracket is
mounted so the unit can slide down on to the Bracket hooks
– the surface that the Bracket is being mounted on is strong
enough to hold the weight of the fully assembled Steamer
– you have obtained the necessary screws to mount the Bracket
to the wall or cabinet
NOTE: Be sure you are using the correct screw-type for the surface
to which you are mounting the Bracket. Check manufacturer's
recommendations or ask someone at your local hardware store
what screw-type will work best, and be sure the screw head is
large enough to cover the holes.
Tool Caddy Installation:
• Hold Wall Bracket in desired location and mark the screw hole
positions with a pencil (position Bracket over a stud, if possible).
• Check levelness of
the location with a
carpenter's spirit level.
• Screw the Wall Bracket
firmly in place.
Continued on next page
Value Pack Features & Details
17