Table of Contents
Advertisement
Next, with the power switch in the
OFF
position, confirm that the power cord is plugged into the power outlet next to
the power switch.
Now plug the
USB A to B cable
into the USB B-type port, do not plug the other end in yet.
Finally install the filament on the
spool holder
and screw in the nut.
Do not over tighten.
Congratulations! You have completed the initial hardware installation! If you're ready to start printing, proceed to the
next step: Software Installation.
７
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Pro 3D Printer and is the answer not in the manual?
Questions and answers