Setting Parameters; Initial Print - PowerSpec Pro 3D Printer Startup Manual

To heat the right extruder and feed material, click the right extruder on the upper right corner of the control panel and
manually modify the temperature in the "Right Target" setting for the extruder temperature control changing the
temperature to 220°C. A red line will be plotted in the temperature map. When the actual (Current) temperature
reaches 220°C you can pull the filament out.
6.5

Setting Parameters

Before generating Gcode, specific parameters can be set up to customize various aspects of the print. An explanation
to each of the settings can be found in the
7

Initial Print

CAUTION
3D Printer has been leveled perfectly before leaving factory. However, it will get unleveled during long
distance shipping, please do level the build plate again before starting a print. See below in instruction.
Please firstly heat the build plate to 50
refer to 6.3(Page 18).
First, make sure that you've completed all the steps in the
1. Your dual extruder heads should be bolted in place,
2. Your filament guide tubes is connected,
3. Your filament is mounted on the spool holders.
Once all these have been completed, you can plug in your power supply. If everything is ready, then turn on the power
switch on the back of your 3D Printer.
To level the build plate, you must adjust the three knobs under the build plate.
1. Tighten the knobs(turning them to the right) moves the build plate away from the extruder nozzle.
2. Loosening the knobs(turning them to the left)moves the build plate closer to the extruder nozzle.
EXPLANATION OF GCODE
°C (PLA) or 110°C (ABS) to make this printing start quickly. Please
Un-boxing and Hardware Setup
SETTINGS.
section.
１９