What's Included In The Box; Un-Boxing - PowerSpec Pro 3D Printer Startup Manual

1

What's Included in the Box?

Along with your 3D printer, the box also contains the following:
In the two long boxes on the top of the package, you'll find:
 Power cord x 1pc,
 USB A to B cable x 1pc,
 Sensor Line x 1pc,
 Filament guide tube x 2 pcs.
 Filament spool holder x 2 pcs.
An accessory box on the top of the 3D Printer:
 Dual extruder heads x 1pc,
 4G SD card x 1 pc,
 Bolt, hex wrench and screws kit x 1 bag.
2

Un-boxing

The 3D Printer was carefully packaged at manufacturing facility. Please follow the unboxing steps laid out below.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the
adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and heat resistant

tape that helps to keep the nozzle at a constant temperature.
First, put the box on the floor in a clean and flat surface. Remove the top EPE foam piece and put the two long boxes
aside. You will find 1x power cord, 1x USB A to B cable, 2x filament guide tubes, and 2x spool holders
long boxes.
thin yellow film from the heating plate. It is heat resistant tape that improves the
in these two
２