Feeding The Filament Using The Lcd Screen; Withdrawing The Filament Using Lcd Screen - PowerSpec Pro 3D Printer Startup Manual

When you have removed the guide tube you can remove the filament that is inside the guide tube. To avoid any
blockages during printing, please ensure that the two threads are loaded from the middle. There are two wire trays,
one runs clockwise and the other one runs counter - clockwise, as shown below:
There are two ways of feeding the filament into the extruder head, one is using the LCD screen on the printer itself and
the other is by using the control panel on the Replicator G software.
6.2

Feeding the Filament Using the LCD Screen

1. Turn on the 3D Printer; the display will indicate:
Build from SD
▶
Preheat
Utilities
2. Using the directional arrows to the right of the screen, press the page down key to scroll to the next page. The
display will show:
Preheat
▶ Utilities
Info and Settings
3. Select Utilities; press the OK key of the keypad. The display will show:
Monitor Mode
Change filament
▶
Level Build Plate
Home Axes
１７