Table of Contents
Advertisement
R
T
A
0
4
N
R
T
A
0
4
N
E
d
.
0
.
1
E
d
.
0
.
1
Figure 4-40
Enable SNMP: Choose to enable or disable the SNMP support.
System Description: System description of the device.
System Contact: Contact information of the device.
System name: Name of the device.
System Location: The physical location of the device
Trap IP address: Destination IP address of SNMP trap.
Community name (read-only): Name of the read-only community. This read-only community
allows read operation to all objects in the MIB.
Community name (read-write): Name of the read-write community. This read-write community
allows read and write operation to all objects defines as read-writable in the MIB.
Note:
After configuration, you need to click the Save button appeared on the left panel so that your
configuration can still take effect after the Router reboots.
4.4.4. DNS
Choose "Service→DNS", you can see the DNS screen (shown in Figure 4-41).
Figure 4-41
Attain DNS Automatically: Select this option, so the device will use the DNS servers which
obtained by the WAN interface via the auto-configuration mechanism.
Set DNS Manually: Select this option, and then you need to configure the DNS IP address
manually.
U
s
e
r
'
s
M
a
n
u
a
l
U
s
e
r
'
s
M
a
n
u
a
l
Page 60 of 78
Advertisement
Table of Contents
