Table of Contents
Advertisement
R
T
A
0
4
N
R
T
A
0
4
N
E
d
.
0
.
1
E
d
.
0
.
1
MAC Address Control: The router supports the MAC address control on Ethernet port. Select
the LAN interface on which you want to run MAC Address Control. Click the Apply Changes
button to make the configuration take effect. For example, if you enable the MAC address
control on "LAN1", then the traffic from interface "LAN1" will be flowed only when its MAC
address matches the Current Allowed MAC Address Table, otherwise the traffic will be
dropped by the router.
New MAC Address: This field allows you to add a new MAC address to the Current Allowed
MAC Address Table. To add a new MAC address, enter the MAC address and then click Add
button.
Current Allowed MAC Address Table: Displays the current allowed MAC address. Click the
Delete button and then the corresponding MAC address will be deleted.
After configuration, click Apply Changes button to save your changes.
Note:
After configuration, you need to click the Save button appeared on the left panel so that your
configuration can still take effect after the Router reboots.
4.2.2.2. DHCP
Choose "Setup→LAN→DHCP" menu, and then you will see the DHCP Mode screen (shown in
Figure 4-7). Here you can configure the DHCP mode of your ADSL Router as None, DHCP Relay or
DHCP Server. DHCP stands for Dynamic Host Control Protocol. The DHCP Server gives out IP
addresses when a device is booting up and request an IP address to be logged on to the network.
U
s
e
r
'
s
M
a
n
u
a
l
U
s
e
r
'
s
M
a
n
u
a
l
Page 25 of 78
Advertisement
Table of Contents
