Table of Contents
Advertisement
R
T
A
0
4
N
R
T
A
0
4
N
E
d
.
0
.
1
E
d
.
0
.
1
Click the Add Route button to add the new route in the Static Route Table.
The Static Route Table shows the current static route entries.
Note:
After configuration, you need to click the Save button appeared on the left panel so that your
configuration can still take effect after the Router reboots.
4.3.1.2. RIP
Choose "Advanced→Route→RIP" menu, you can configure the RIP settings in the next screen
(shown in Figure 4-25). RIP is an internet protocol you can set up to share routing table information
with other routing devices.
Figure 4-25
RIP: Select to enable the RIP function or not. Click the Apply button to save your configuration.
Interface: Select the interface on which you want to enable RIP.
Recv Version: Indicate the RIP version in which information must be passed to the device. It
can be accepted into its routing table.
Send Version: Indicate the RIP version this interface will use when it sends its route
information to the other device.
Click the Add button to add a RIP configuration to the Rip Config List. Click the Delete button to
delete it.
The RIP Config List shows the current RIP setting of the device.
Note:
After adding a new entry, a Save button will appear on the left panel. You need to click the Save
button to make your changes take effect.
U
s
e
r
'
s
M
a
n
u
a
l
U
s
e
r
'
s
M
a
n
u
a
l
Page 43 of 78
Advertisement
Table of Contents
