Table of Contents
Advertisement
R
T
A
0
4
N
R
T
A
0
4
N
E
d
.
0
.
1
E
d
.
0
.
1
Current ATM VC Table: ATM settings are used to connect to your ISP. Your ISP provides VPI
(Virtual Path Identifier), VCI (Virtual Channel Identifier) settings to you. In this Device, there is
one VC configured by default. You can totally setup 8 VCs on different encapsulations, if you
apply 8 different virtual circuits from your ISP. You need to activate the VC to take effect.
: Click this icon to enter the VC modification page. Besides, some advanced settings can
be configured there.
: Click this icon to delete the corresponding VC.
VPI: Identifies the virtual path between endpoints in an ATM network. The valid range is
from 0 to 255. Please input the value provided by your ISP.
VCI: Identifies the virtual channel endpoints in an ATM network. The valid range is from 32
to 65535 (1 to 31 is reserved for well-known protocols). Please input the value provided by
your ISP.
Encapsulation: Specifies the type of Multiplexing, either LLC or VC-Mux. Please note that
VC-Mux is not available for IPoA channel mode.
Channel Mode: There are six channel modes, 1483 Bridged, 1483 MER, PPPoE, PPPoA,
1483 Routed and IPoA. Please choose the mode that you want to use.
Enable NAPT: Choose to enable the NAPT function or not.
Enable IGMP: Choose to enable the IGMP function or not.
PPP Settings: These parameters are only available for PPPoE and PPPoA channel mode.
User Name: Enter your user name for your PPPoE/PPPoA connection.
Password: Enter your password for your PPPoE/PPPoA connection.
Type: Select Continuous, Connect on Demand or Manually for the network connection.
Continuous means the Internet connection will always keep on. Connect on demand is
dependent on the traffic. If it's idle (there is no traffic) for a pre-specified period of time), the
connection will tear down automatically. And once there is traffic send or receive, the
connection will be automatically on. Manually means you have to manually connect or
disconnect your Internet by clicking the Connect or Disconnect button at the bottom of
this page.
Idle Time (min): Specifies the idle time for Connect on Demand type.
WAN IP Settings: These parameters are only available for 1483 MER and 1483 Routed
channel mode. Please note that for1483 Routed mode, DHCP is not available.
Type: Selects to use Fixed IP or DHCP. If Fixed IP is selected, then you have to fill the
following parameters, including Local IP Address, Remote IP Address, and Netmask.
Otherwise, these parameters will not be available.
Local IP Address: The IP address of the router on the PVC channel.
Remote IP Address: The gateway's IP address of the router on the PVC channel.
Netmask: The subnet mask of the router on the PVC channel.
Connect/Disconnect: When there is a VC using PPPoE/PPPoA channel and Manually type,
you need to click this button to connect/disconnect the network.
U
s
e
r
'
s
M
a
n
u
a
l
U
s
e
r
'
s
M
a
n
u
a
l
Page 21 of 78
Advertisement
Table of Contents
