Exmark METRO Operator's Manual page 19

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.8.6
NOTE: The neutral lock/park brake latches must be able to be
3.8.7
Neutral Lock /
Park Brake Latch
Drive Linkage
NOTE: Neutral lock/park brake latch clearance should be
checked when there is a slight upward force placed
on the drive levers to remove any "slack" in the
linkage.
After clevis pin has been inserted, install hairpin into
hole on the clevis pin between the neutral lock/park brake
latch and drive lever (See Figure 11). Repeat procedure on
opposite side of unit.
Clevis Pin
Drive
Lever
Hairpin
Drive Lever Hardware Location
Adjust brakes by adjusting wingnut on the upper end of each
brake rod. Position the wingnut so the brakes will engage
when the drive levers are squeezed enough to place the
neutral lock/park brake latches into the "park brake" position.
moved into the park brake position, if not, the brake
linkages must be adjusted again.
Squeeze the drive levers and move both neutral lock/park brake
latches to the rear into the neutral lock position. Mower should
move forward and backward freely, if not, readjust the brakes.
Squeeze the drive levers and move the neutral lock/park brake
latches to the front into the park brake position. Mower should
not move forward and backward freely, if it does, readjust the
brakes.
www.mymowerparts.com
3/16" TO 1/4"
FIG. 10
NEUTRAL LOCK
LEVER CLEARANCE
FIG. 11
- 14 -
Drive Linkage
Left Side
Shown
Neutral Lock /
Park Brake Latch