Starting The Projector - Kodak DP2900 User Manual

User Guide KODAK DP2900 Digital Projector

Starting the Projector

We recommend using a surge protector power strip when connecting
your projector.
1. Remove the lens cap.
2. Plug the power cord into the side of the projector, then plug it into
Note:
3. Turn on the lamp by pressing the
4. If you connected a video source, turn it on.
22
your electrical outlet.
The fans start to run, and the Lamp LED on the top of the
projector lights orange until the software has initialized. When
initialization is complete, the Lamp LED lights green. A green
Lamp LED indicates that you can press the
to turn the lamp on and off.
The first time you connect your computer to the projector, the
computer may display a message stating that new hardware
was found. The Add New Hardware Wizard may appear. Use
the Wizard to load the correct driver (the computer considers
the projector a Plug and Play Monitor).
keypad.
The startup screen appears.
The video image should display on the projection screen. If a
computer source is active, press the
keypad (page 30) or press the
display your video image. You can select a default source to
determine which source the projector examines first during
power-up for active video; see "Default Source" on page 39.
Use the buttons
volume
lamp on/off
button
lamp on/off
button
source
button on the remote to
video
to adjust the volume.
button
on the
on the