Select Button; Care Of The Projector - Kodak 550 Manual

SELECT BUTTON
Depress and hold the SELECT button , at the same time
rotating the slide tray in either direction to align with
the gate index the identification number of the particular
slide you wish to show. When you release the button the
selected slide will be " on the screen. " Depressing the
select button provides instant "editing" of the projected
slide.
AFTER THE SHOW
1.lf automatic slide-changing is being used , turn the auto-
matic timer to MANUAL.
2. Remove the slide tray (identification number " 0 " at
gate index).
3. Depress the FAN button : allow the fan to run until the
projection lamp has cooled : then depress the OFF button.
4. Unplug the power cord. Fold the cord by putting the
two ends of the cord together and folding it in about 5-
inch lengths. Replace it in the cord compartment. Unplug
and replace the remote control (if used) .
5. Lower the projector by turning the ELEVATE knob
counterclockwise .
6. Turn the FOCUS knob counterclockwise to retra ct the
lens.
CARE OF THE PROJECTOR
WARNING : After use. always make sure that the power
cord is disconnected and that the projection lamp has
cooled sufficiently before attempting to disassemble the
projector for cleaning or lamp replacement. Cooling can
be accelerated by running the fan with the lamp turned
off: just depress the FAN button .
PROJECTION-LAMP REPLACEMENT
Remove the OPTICS COVER by turning the cover screw
toward the back of the projector until the cover can be
removed from the projector . Remove the lamp by pulling
it stra ight out.
To install a lamp. pla ce the center post of the lamp in
13