Snmp Agent - Ubiquiti airFiber AF-5X User Manual

airFiber ® AF-5X User Guide
• Ping Interval Specify the time interval (in seconds)
between the ICMP echo requests that are sent by Ping
Watchdog. The default value is 300 seconds.
• Startup Delay Specify the initial time delay (in seconds)
until the first ICMP echo requests are sent by Ping
Watchdog. The default value is 300 seconds.
The Startup Delay value should be at least 60 seconds
as the network interface and wireless connection
initialization takes a considerable amount of time if the
AF-5X is rebooted.
• Failure Count to Reboot
echo response replies. If the specified number of ICMP
echo response packets is not received continuously,
Ping Watchdog will reboot the AF-5X. The default value
is 3.
• Save Support Info This generates a support
information file.

SNMP Agent

Simple Network Monitor Protocol (SNMP) is an application
layer protocol that facilitates the exchange of management
information between network devices. Network
administrators use SNMP to monitor network-attached
devices for issues that warrant attention.
The AF-5X contains an SNMP Agent, which does the
following:
• Provides an interface for device monitoring using SNMP
• Communicates with SNMP management applications
for network provisioning
• Allows network administrators to monitor network
performance and troubleshoot network problems
For the purpose of equipment identification, configure the
SNMP Agent with contact and location information:
SNMP Agent Enables the SNMP Agent.
• SNMP Community Specify the SNMP community
string. It is required to authenticate access to
Management Information Base (MIB) objects and
functions as an embedded password. The AF-5X also
supports a read-only community string; authorized
management stations have read access to all the objects
in the MIB except the community strings, but do not
have write access. The AF-5X supports SNMP v1. The
default SNMP Community is public.
• Contact Specify the contact who should be notified in
case of emergency.
• Location Specify the physical location of the AF-5X.
Ubiquiti Networks, Inc.
www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Specify the number of ICMP
Web Server
The following Web Server parameters can be set:
Secure Connection (HTTPS)
uses secure HTTPS mode.
Secure Server Port
• If secure HTTPS mode is used,
specify the TCP/IP port of the Web Server.
Server Port If HTTP mode is used, specify the TCP/IP port
of the Web Server.
Session Timeout Specifies the maximum timeout before
the session expires. Once a session expires, you must log
in again using the username and password.
SSH Server
The following SSH Server parameters can be set:
SSH Server
This option enables SSH access to the AF-5X.
• Server Port Specify the TCP/IP port of the SSH Server.
• Password Authentication
authenticate using administrator credentials to grant
SSH access to the AF-5X; otherwise, an authorized key is
required.
• Authorized Keys Click Edit to import a public key file
for SSH access to the AF-5X instead of using an admin
password.
- Choose File Click Choose File to locate the new key
file. Select the file and click Open.
- Import Imports the file for SSH access.
Enabled
- Enables the specific key. All the added keys
are saved in the system configuration file; however,
only the enabled keys are active on the AF-5X.
- Type Displays the type of key.
Chapter 8: Services Tab
If enabled, the Web Server
If enabled, you must
25