Programming Mode - La Marzocco GB/5 Software Programming Manual

GB/5 - FB/80
LaMarzocco 09:30
e -
Description
• To change any configurable parameter the operator
must first enter into the programming mode.
• There are several levels within the programming
mode that allow the restriction of specific parameters
depending upon the password entered.
Display
1
LaMarzocco 09:30
2
Water Volume
Programming
3
LaMarzocco 09:30 4
Password 5
?????
6
7
www.lamarzocco.com

Programming Mode

Press and hold the button on the group 1 keypad. After approximately 5 seconds the
following display appears.
This is the Barista Level. Press the
ON
OFF
When finished, press to
Press and hold the button on the group 1 keypad. After approximately 10 seconds the
following display appears.
Using a combination of the following buttons (the first 5 buttons on the group 1 keypad) enter the
appropriate 5 digit password.
The parameters available after entering the password are dependant upon the password entered.
If a technician password is entered then the technician level parameters will be made
available....etc. Press
MODE
When finished, press to exit programming mode.
ON
OFF
The four programming levels are as follows:
• Barista Level - No Password Necessary. Limited
parameters are available.
• Technician Level - Technician password needed.
Barista level parameters plus additional
parameters are available.
• Factory Level - Factory password needed. Barista
Level and Technician level parameters plus
additional parameters are available.
• Roaster Level - Roaster password needed. A
specific set of parameters are made available only
to those entering this password.
Operating Procedure
MODE
button to scroll through the available parameters.
exit programming mode.
_
+
ENTER
MODE
to scroll through the available parameters.
Version 1.3
Accessing Programming Mode
3