Table of Contents
Advertisement
Editing in the Phrase Scope
Editing the Pitch/Time/Formant/Dynamics
Here's how to edit the Pitch/Time/Formant/Dynamics in the specified region of the phrase.
1. Select the parameter that you want to edit.
At the left of the controller display area, press one of the
parameter you want to edit:
PITCH (Control change number 16)
TIME (control change number 17)
FORMANT (control change number 18)
DYNAMICS (control change number 11 Expression)
* You cannot edit the formant if the sample was encoded in a type other than
the FORMANT button, the red line indicating the formant will not be displayed.
2. Use one of the following methods to specify the region that you want to edit.
To select a desired region
To extend the selected region
To select an event
To select multiple events
To cancel your selection
3. Use the
[Curve select]
Flat
: The parameter will be increased or decreased equally.
Linear
78
[PITCH]
Drag the mouse to left or right in the controller display area. To se-
lect a region in grid units, turn on the Grid Snap button.
Hold down the [Shift] key of your keyboard and click in the control-
ler display area.
Click the waveform display area.
Drag the mouse to left or right in the waveform display area.
Click in an unselected part of the controller display area, or click the
border.
buttons to select the type of curve.
fig.03-ps03
You can select one of three curves to specify how the parameter will change. Click
either the Flat, Linear, or Rounded curve button.
: The parameter will be increased or decreased in a straight line.
[Controller select]
,
,
, or
[TIME]
[FORMANT]
Varies the pitch.
Varies the playback speed.
If the sample was encoded as "SOLO," varies the
tonal character (formant).
Varies the volume.
buttons to select the
.
[DYNAMICS]
Even if you press
"SOLO."
Advertisement
Table of Contents
