Table of Contents
Advertisement
10
In the dialog box that appears, input the following into the "Open" field,
and click [OK].
D:\ENGLISH\DRIVER\USB_XP2K\SETUPINF.EXE
11
The SetupInf dialog box will appear.
You are now ready to install the driver.
Installing the driver
12
Use the USB cable to connect the VariOS to your computer.
fig.02-USB
Computer
13
Set the VariOS's power switch to the ON position.
If the "Driver Signing Options" setting was not set to "Ignore", a "Digital Signature Not
Found" dialog box will appear.
If "Driver Signing Options" is set to "Warn,"
1. Click [Yes].
2. Continue the installation.
If "Driver Signing Options" is set to "Block"
1. Click [OK].
2. When the "Found New Hardware Wizard" appears, click [Finish].
3. Using the procedure described in the "Troubleshooting" section "Q. Device Manager
shows "?", "!", or "USB Composite Device"" (p. 143), delete the data for the VariOS
that was wrongly detected. Then install the driver using the procedure described in
"Installing the Driver" (p. 22). When doing so, set "Driver Signing Options"in step 5 to
"Ignore."
USB cable
USB connector
The drive name "D:" may
be different for your
system. Specify the drive
name of your CD-ROM
drive.
VariOS
(Rear)
You must power up the
VariOS according to the
procedure given on p. 49.
Installation
27
Advertisement
Table of Contents
