Changing The Location Of A Event - Roland VariOS User Manual

Changing the location of a event

Events demarcate the notes that you edit in the Scope Editor screens (p. 76). In the Groove Scope (p.
87), you can slice the sample at the locations of the events you specify here, and reassemble the slices
as desired.
Initially, V-Producer will automatically place events in the sample, but you are free to add, delete, or
adjust the location of the events.
1. As described in steps 1–3 of "Changing the encoding type," enter Edit mode.
2. The events are shown in the event display area.
fig.03-23
3. Click one of the Event Edit tools to select a tool, and edit the events in the event display area.
* Try using the play step
4. Finally, click the [Save] button. The sample will be saved, and re-sent to the VariOS. If you click
the [Cancel] button, your changes will be discarded and you will exit Edit mode.
fig.03-24
Arrow.................... Drag an event to move it
Pen......................... Click to add an event
Eraser .................... Click to delete an event
Slider (Depth) ...... Moving the slider will cause an event to be automatically
assigned wherever a strong attack (a point where the volume
changes suddenly) is detected.
button to play individual slices (waveform divided by events).
Re-encoding a sample (Wave Edit)
67