Disassembly Procedures For Models Jxt9030Cdp; Jxt9036Cdp, Jxt9048Cdp, Jxt9130Cdp, Jxt9136Cdp; Halogen Light Removal; Heat Lamp Removal - Jenn-Air JXT5830ADB Service

Disassembly Procedures
!
Disassembly for models JXT9030CDP,
JXT9036CDP, JXT9048CDP, JXT9130CDP,
JXT9136CDP

Halogen Light Removal

1. Turn off power to the light bulb.
2. Twist light bulb counterclockwise from the socket.
NOTE: A suction cup may be required for light bulb
removal. One may be obtained from a local
hardware store.
3. Reverse procedure to reinstall light bulb.

Heat Lamp Removal

1. Turn off power to the heat lamp.
2. Twist heat lamp counterclockwise from the socket.
NOTE: A suction cup may be required for heat lamp
removal. One may be obtained from a local
hardware store.
3. Reverse procedure to reinstall heat lamp.
Grease Filter/Grease Filter Cover Removal
1. Turn off power to the blower motors.
2. Remove grease filter covers by using handles and
pulling filter cover toward the rear of the vent hood.
3. Pivot front of grease filter upward, then pull the filter
downwards and toward the rear to remove.
4. Reverse procedure to reinstall grease filters and
grease filter covers.
©2004 Maytag Services
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
Halogen Light Socket Removal
1. Disconnect power to vent hood.
2. Remove halogen light, see "Halogen Light Removal"
procedure.
3. Remove grease filters and covers, see "Grease Filter/
Grease Filter Cover Removal" procedure.
4. Remove light panel, see "Light Panel Removal"
procedure.
5. Remove screws securing light socket and remove
light socket.
6. Reverse procedure to reinstall light socket.

Heat Lamp Socket Removal

1. Disconnect power to vent hood.
2. Remove heat lamp, see "Heat Lamp Removal"
procedure.
3. Remove grease filters and covers, see "Grease Filter/
Grease Filter Cover Removal" procedure.
4. Remove screw securing electrical connector cover.
5. Label and disconnect heat lamp socket electrical
connection.
6. Remove screws securing lamp reflector.
7. Remove screws securing lamp socket and remove
lamp socket.
9. Reverse procedure to reinstall lamp socket.
16023510 13