Sony HT-GT1 Operating Instructions Manual page 26

Pairing this system with a
BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with
each other beforehand. Once a
pairing operation is performed, it
does not need to be performed
again.
If your device is an NFC-compatible
smartphone, the following pairing
procedure is not necessary.
For details, see "Connecting a
smartphone with one touch (NFC)"
(page 27).
1
Place the BLUETOOTH device
within 1 meter (3 feet) from the
system.
2
Press BLUETOOTH on the
subwoofer to select the
BLUETOOTH function.
"BT AUDIO" appears on the display.
Note
If the system is already connected to a
BLUETOOTH device, press BLUETOOTH
on the subwoofer to disconnect the
BLUETOOTH device.
3
Hold down BLUETOOTH on the
subwoofer for 2 seconds or
more.
"PAIRING" flashes on the display.
4
Perform the pairing procedure
on the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
26
GB
5
Select the model number of this
system from those shown on
the display of the BLUETOOTH
device.
For example, select "SONY:HT-GT1."
If passkey is required on the
BLUETOOTH device, enter "0000".
6
Perform the BLUETOOTH
connection on the BLUETOOTH
device.
When pairing is completed and the
BLUETOOTH connection is
established, BLUETOOTH device
name appears on the display.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.
Notes
You can pair up to 9 BLUETOOTH
ˎ
devices. If the 10th BLUETOOTH device
is paired, the oldest paired device will
be deleted.
"Passkey" may be called "Passcode,"
ˎ
"PIN code," "PIN number" or "Password,"
etc., depending on the device.
The pairing standby status of the
ˎ
system is canceled after about 5
minutes. If pairing is not successful,
repeat from step 1.
If you want to pair with another
ˎ
BLUETOOTH device, repeat steps 1 to 6.
To cancel the pairing operation
Hold down BLUETOOTH on the
subwoofer for 2 seconds or more
until "BT AUDIO" appears on the
display.