Kenmore 625.75130 Use & Care Manual page 18

4. Press SELECT 1 again to display the "12 or 24 hr"
screen.
12 OR 24 HOUR CLOCK: All time displays are
shown in standard clock time (1 to 12 AM; and 1 to
12 PM) at the 12 hr default setting. If 24 hour time
format is desired, set to 24 hr by pressing the
button.
5. Press SELECT 1 again to display the "Gallons or
Liters" screen.
GALLON OR LITER READINGS: Water usage and
flow rate displays are shown in gallons at the default
setting. If you prefer liters, change this setting from
"Gals" to "Liter" by pressing the
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
18
Controller Features
Figure 29
r
UP
Figure 30
r
UP button.
6. Press SELECT 1 again to display the "Recharge Days"
screen.
MAXIMUM DAYS BETWEEN REGENERATIONS: The
electronic controller automatically determines regen-
eration frequency. This provides the greatest operat-
ing efficiency and, under most conditions this feature
will be left in its default mode. However, you can set
this feature to force a regeneration every set number
of days. You may want to do this if, for example,
your water supply contains iron and you want the
softener to regenerate at least once every few days
to keep the resin bed clean. Use the
DOWN buttons to change the number of days (up to
15). If no change is desired, continue to next step.
7. Press SELECT 1 to return to the normal run (time of
day) screen.
TANK LIGHT
To turn on the light inside the salt storage tank, press
the TANK LIGHT button on the faceplate. Press this
button again to turn the light off. It will also turn off
automatically after 15 minutes.
Figure 31
r s
UP or
Tank Light
Icon
Figure 32