Table of Contents
Advertisement
SET WATER HARDNESS NUMBER
If you completed the previous step, the word "HARD-
NESS" should show in the display. Otherwise, press the
SELECT 1 button several times until it does.
r
1. Press the
UP or
hardness of your water supply, in grains per gallon.
The default is 25.
NOTE: If your water supply contains iron, compensate
for it by adding to the water hardness number.
For example, assume your water is 20 gpg hard
and contains 2 ppm iron. Add 5 to the hardness
number for each 1 ppm of iron. In this example,
you would use 30 for your hardness number.
2 ppm iron x 5 = 10
(times)
If your water supply contains iron, it is recom-
mended that you clean your water softener resin
bed at least every 6 months. Your local Sears
store has Water Softener Cleaner (Part Number
75534) available.
2. When finished setting your water's hardness number,
press the SELECT 1 button, and the display will
change to show the "Recharge Time" screen.
SET RECHARGE (REGENERATION) START TIME
If you completed the previous step, the words "RE-
CHARGE TIME" should show in the display. Otherwise,
press the SELECT 1 button several times until they do.
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
14
Programming the Softener
Figure 18
s
DOWN buttons to set the
20 gpg hardness
+10
30 HARDNESS NUMBER
Figure 19
1. The softener's default recharge start time is 2:00 AM.
This is normally a time of day when water is not
being used in the household. Hard water bypasses
the softener if the household draws water during the
recharge cycle. If a different recharge start time is
r
desired, press the
UP or
change the time, in 1-hour increments. Be sure AM or
PM is correct.
2. When the desired recharge start time is displayed,
press the SELECT 1 button, and the display will change
to show one of the "Salt Type" screens shown below.
SET SALT TYPE
If you completed the previous step, either "NaCl" (for
Sodium Chloride) or "KCl" (for Potassium Chloride)
should show in the display. Otherwise, press the
SELECT 1 button several times until one of them does.
r
s
1. Press the
UP or
DOWN buttons to set the type
of salt you will be using in your water softener. The
default is NaCl (standard Sodium Chloride water sof-
tener salt). If you will be using KCl (Potassium
Chloride) instead, be sure to set salt type to KCl. This
setting adjusts the regeneration cycle times to com-
pensate for the different rate at which KCl dissolves.
See also the following page for more information on
salt types.
2. When the correct salt type is displayed, press the
SELECT 1 button, and the display will return to the
normal run (time of day) screen.
s
DOWN buttons to
Figure 20
Figure 21
Hide quick links:
Advertisement
Table of Contents
