Controller Features - Kenmore 625.75130 Use & Care Manual

EXTRA RECHARGE
Sometimes, a manually initiated recharge (regeneration)
may be desired, or needed. Two examples are:
You have used more water than usual (guests visiting)
and you may run out of soft water before the next
automatic regeneration.
You did not add salt to the softener before it ran out.
Add salt to the softener before regenerating.
You can start a regeneration immediately, or you can
set the controller to regenerate at the next preset
recharge time (2:00 AM, or as set).
RECHARGE NOW
Press the ON/OFF-HOLD button and hold for 3 sec-
onds, until the words "RECHARGE", "Serv" and "Fill"
begin to flash in the display. The softener enters the fill
cycle of regeneration immediately. This regeneration
will take about 2 hours to complete. Then, you will
have soft water again.
NOTE: If the "Clean Feature" is set ON, the normal
regeneration cycle is preceded by a cleaning
backwash and rinse. The words "CLEAN" and
"Bkwsh" or "Rinse" flash in the display, along
with the minutes of the clean cycle remaining.
RECHARGE TONIGHT
Press and release (do not hold) the ON/OFF-HOLD
button. "RECHARGE TONIGHT" will begin flashing in
the display, and the softener will begin regeneration at
the next preset recharge time (2:00 AM, or as set). If
you decide to cancel the regeneration before it starts,
press and release the ON/OFF-HOLD button once
more. "RECHARGE TONIGHT" will stop flashing in the
display.
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
16

Controller Features

SALT MONITOR SYSTEM
The water softener has a salt monitor indicator light to
remind you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added
NOTE: The salt monitor system estimates salt levels, and
To set this monitor system:
1. Lift the salt lid and level the salt in the storage tank.
2. The salt level scale, on the brinewell inside the tank,
Level
3. Press the SALT LEVEL ADJUST button as many times
4. If you want to change the level that the "Low Salt"
Figure 22
5. If you want to turn the salt monitor off, press the
Figure 23
to the water softener.
accuracy will vary with different salts.
has numbers from 0 to 8 (see Fig. 24). Observe the
highest number the leveled salt is at, or closest to.
SALT
LEVEL
Salt Level
Bars
Brinewell
Salt
Numbers
as necessary to make the salt level bars in the dis-
play (see Fig. 24) match the number on the brinewell.
indicator comes on, press the SIGNAL LIGHT
ADJUST button as many times as necessary to make
the highest star (*) in the display (see Fig. 24) match
the number on the brinewell. For example, if you set
the highest star at level 2, then the "Low Salt" indi-
cator will flash when the salt level is at level 2 or
below.
SIGNAL LIGHT ADJUST button several times, until
"OFF" shows in the display next to the number 8.
Kenmore Water
Ligne
Kenmore au
Figure 24
Figure 25