Supermicro X8DT6 User Manual page 13

Jumper Description
JBT1 CMOS Clear
JI 2 C1/JI 2 C2 SMB to PCI Slots
JPG1 VGA Enable
JPL1/JPL2 LAN Ports 1/2 Enable
JPS1 SAS Enable
JWD Watch Dog
Connector
COM1/COM2
FAN 1-8
Floppy
JIBTN1
J5
JD1
JF1
JL1
JOH1
2
JPIC 1
JPW1
JPW2, JPW3
JWF1
JWOL
LAN1/2, IPMI_LAN
I-SATA0 ~ I-SATA5
SAS 0~3, 4~7
SP1
TPM
T-SGPIO-1/T-SGPIO-2
USB 0/1, 2,3, 4/5, 6/7
VGA
LED Description
D1 BMC Heartbeat LED Indicator (X8DTE-F/X8DT6-F only)
LE1 Onboard Standby LED Indicator
LED1 SAS LEDs (LED1: SAS Heartbeat LED) (X8DT6/X8DT6-F only)
Note: Jumpers JPL1/JPL2 are available for the PCB Rev. 1.31 or a later vision of
motherboard only.
X8DT6/E-F Quick Reference
Default Setting
(See Section 2-7)
2-3 (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled) (For a Rev. 1.31 or later board)
Pins 1-2 (Enabled) (X8DT6/X8DT6-F)
Pins 1-2 (Reset)
Description
COM1/COM2 Serial Port/Header
System/CPU Fan Headers (Fans 7~8: CPU Fans)
Floppy Disk Drive Connector
RAIDKey for RAID 5 SAS support (optional for X8DT6/X8DT6-F)
2
IPMB I C Header (for an IPMI card) (X8DTE-F/X8DT6-F)
PWR LED/Speaker Header (Pins 4~7: Speaker)
Front Panel Connector
Chassis Intrusion Header
Overheat LED Header
2
Power Supply SMBbus I C Header
24-pin ATX Main Power Connector (Warning on Pg. 1-4)
8-pin Secondary Power Connector (Warning on Pg. 1-4)
DOM (Disks_On_Module) Power Header
Wake-On-LAN Header
Gigabit Ethernet (RJ45) Ports 1/2 & IPMI_Dedicated LAN
IPMI_LAN is for
( X8DTE-F/ X8DT6-F only)
(Intel South Bridge) SATA Ports
SAS Ports 0~3, 4~7 (X8DT6/X8DT6-F only)
Internal Speaker/Buzzer
TPM (Trusted_Platform_Module) Header
Serial General Purpose Input/Output Headers
Universal Serial Bus (USB) Ports
VGA Connector
1-5
Chapter 1: Introduction