FLIR IP Series Instruction Manual page 23

5 Setup
2. Configure the following:
• Brightness: Adjust the brightness of the image between 0 and 100.
• Contrast: Adjust the contrast of the image between 0 and 100.
• Saturation: Adjust the color saturation of the image between 0 and 100.
• Sharpness: Adjust the sharpness of the image between 0 and 100. Higher sharp-
ness will make edges in the image clearer, but may increase noise in the picture.
• Gamma: Adjust the gamma level of the image between 0 and 100. The gamma lev-
el controls the balance between dark and bright parts of the camera image. It is rec-
ommended to keep this value near the mid-point as a low gamma level can produce
a washed-out image, and high gamma can create a dark, oversaturated image.
• Anti-flicker: Select the anti-flicker mode depending on the environment:
• Outdoor: The system will use the exposure mode to adjust for lighting.
• 50Hz: The system will compensate for lighting using 50Hz AC power (i.e. for
Europe).
• 60Hz: The system will compensate for lighting using 60Hz AC power (i.e. for
North America).
• Exposure: Select the exposure mode.
• Auto: The system will automatically adjust the brightness and exposure based
on the environment.
• Low Noise: The system will automatically adjust the gain to reduce the amount
of noise in the image. Set the minimum and maximum Gain Scope. Increasing
the max gain will increase the noise reduction.
• Low Motion Blur: The system will automatically adjust the shutter to reduce mo-
tion trails in the image. Set the minimum and maximum Shutter Scope.
• Manual: Configure manual exposure settings. Configure the Shutter Regulate
and Gain Scope.
• White Balance: Select the white balance mode.
• Auto: Automatic white balance.
• Sunny: White balance mode for daylight.
• Night: White balance mode for night time.
• Customized: Manual white balance. Use the sliders to configure the Red Con-
trol and Blue Control.
• Auto Iris (auto iris cameras only): Select ON to enable auto iris or OFF to disable
auto iris. If your camera supports the auto iris feature and is installed outdoors, it is
recommended to select OUTDOOR.
• Day & Night: Select one of the following day / night modes.
• Auto: Camera will automatically change between day and night mode based on
the lighting (recommended).
• Color: Camera will be in day mode at all times.
• B/W: Camera will be in black and white at all times.
• BLC Mode: Select one of the following modes.
• BLC (Backlight Compensation):The camera automatically adjusts the expo-
sure for a clearer image in the darkest areas of the video. Click Default to use
default settings or Customized to adjust the BLC area. The darker the area you
select, the brighter the image will be.
#LX400038; r. 1.0/18537/18537; en-US
15