FlexRadio Systems FLEX-5000C Quick Start Manual page 8

Set your Time Zone and the System date/time
You should tell your computer what time zone you live in and ensure the correct date/time is set.
Using your mouse, double-click the clock in the lower right corner of the desktop view.
Click the Time Zone tab
Click the circled arrow to open the list of time zones
Select your time zone from within the list and click it
Click Apply
Click the Date and time tab
Set your date by clicking on the calendar
Set your time by entering where shown then click apply
Setup process ends, your desktop view appears and system begins regular
operation
Congratulations, the computer system within your FLEX-5000C is now ready to use. The next
steps are the first-time run of the PowerSDR 1.x application.
Start PowerSDR 1.x
Specific information about your radio is stored in the hardware in read-only memory. PowerSDR
1.x will read this information from on-board memory during its first use. You will see these steps
when your radio is new and each time you install an updated version of PowerSDR 1.x (if you do
not import/copy the database). Starting the PowerSDR 1.x application after the initialization
process is complete will not display the extra screens.
Double-click PowerSDR 1.x on the desktop or select it from the start menu
The first time PowerSDR 1.x runs, it will adopt some stored values from your radio's
hardware as shown below
FLEX-5000C Quick Start Guide Version 1.2 Page 8