Using The Extension Pole - Eckman HPT1 Instruction Manual

Using the E xte nsion P ole
With the extension pole you can also trim in difficult to reach areas.
1. Remove the protection cap from the extension pole connection. Store the
protection cap in a safe place.
2. Insert the extension pole as far as it will go into the pole connection (6). The
extension pole fits only in one position into the connection.
3. Tighten the hedge trimmer and the extension pole together. Turn the seal
only hand tight. When inserting the extension pole into the pole conne ction,
the switch of the hedge trimmer will be out of order, the integrated power
plug will provide the AC power to the hedge trimmer
4. If the extension pole is not used, the power plug adapter (page IV No. 17) has
to be used
5. Connect the male p lug of the e xtension pole with the female plug of the 1 0 m
p owe r ca b le a nd the n p lug into a ny conve nie nt 1 3 Amp ma ins outle t.
6. Put the shoulder strap on your shoulder and adjust to the desired length
II
Before changing the angle of inclination or moving the handle adjustment,
disconnect the plug from power mains.
Any questions or problems – please call the Eckman Helpline on 0871 590 5917 or go to www.eckman.co.uk
Ope rating
I
7. To start the hedge trimmer,
press and hold the safety
switch
press
(13).
With the handle adjustment (11)
on the extension pole you can
incline the hedge trimmer to an
angle up to 90° to the left and to
the right.
7
(12) pressed
the ON/OFF switch
and