Appendix; Adding And Registering Handsets; Register A Handset To The Telephone Base - AT&T CL83101 User Manual

Appendix

Adding and registering handsets

Your telephone can support up to 12 cordless handsets. A new handset
(AT&T model CL80111, purchased separately) must be registered to the
telephone base before use. You must register each handset separately.
The handsets provided within your product box are already registered as
HAND�ET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HAND�ET 12).

Register a handset to the telephone base

1. Make sure the handset is out of the telephone base or
charger and shows �ut H� on BA�E to register before you
begin registration.
2. Put the handset you wish to register on the telephone
base cradle.
3. Both the handset and the telephone base show
Registering... �lease wait and the IN U�E light on the
telephone base turns on. Then HAND�ET X Registered
appears on both the handset and the telephone base
HAND�ET represents the handset name,
screens ( (
X represents the handset
the telephone base beep and the IN U�E light turns off.
The handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on both screens. Then the
handset shows �ut H� on BA�E to register and the
telephone base returns to idle mode. This may take up
to 5 minutes to occur. Please start again from
Step 1 above.
NOTES:
• You cannot register a handset if any other system handset is in use.
• If you try to register more than 12 handsets to the telephone base,
the telephone base shows Registration slots are full and
sounds 2 beeps.
number). Both the handset and
88
Put HS on BASE
to register
Registering...
Please wait
HANDSET X
Registered
For registration, put the
handset on the telephone
base, not the handset charger.