Advertisement
Light status
Light
Status
Power
On
Off
Ethernet
On
Flashing
Off
Red
Too close
Flashing
Good range
Too far
Red/
Too close
Orange/
Green
Good range
Scrolling
Too far
WPS
On
Flashing
Off
See step 3 for signal strength light descriptions
Connect to router without WPS
If you don't have a WPS button on your hub/router, you can set up your extender using
the web based set-up with an internet browser.
Your extender settings details can be found on the back page of this user guide
and on the back of the extender.
Use the wireless connection software or settings on your device to display the list of
1
available wireless networks in your area.
Find your extender in the list and select it; it's called BTWifiExtndr-XXX.
-
Enter your extender's wireless key.
-
Complete the connection on your device.
-
Enter http://192.168.1.1 in your internet browser address field.
2
Enter your Admin password then click Login.
-
-
Click Start at the bottom then follow the on-screen connection wizard.
When you click Finish your browser will lose connection to the extender
3
(ignore browser errors). The extender's range indicator light will stop flashing
on successful connection.
Now go back to
3
4
Move extender to optimum location.
Full instructions on how to connect devices using different operating systems are in
the Frequently Asked Questions, available at bt.com/producthelp.
What's happening
Extender running normally
Extender turned off
Ethernet connection established
Data is being sent or received
No ethernet connection
Extender not configured to connect to hub/router
2
Go to step
Extender connecting to hub/router
If scrolling for more than 1 min, check your hub/router is switched
on and try moving your extender closer to it.
WPS Connection successful (goes off after 30 sec.)
Authentication in progress or faster flashing indicates connection error
No WPS session in progress
Advertisement
