Light Status; Reset To Factory Settings; Using The Ethernet Cable - BT 300 User Manual

Light status

Light Status
Power On
Off
Ethernet On
Flashing Data is being sent or received
Off
Red
Too close
Flashing
Good range
Too far
Too close
Red/
Green
Good range
Scrolling
Too far
WPS On
Flashing Authentication in progress or faster flashing indicates
Off

Reset to factory settings

If you need to access advanced settings, have forgotten your password or if the extender
stops working you can reset it to its factory settings.
Make sure the extender is plugged in and switched on.
1
2 Press the Reset button for 1 second to restore factory default settings.

Using the ethernet cable

You can connect an additional device to the ethernet port that will use the wi-fi extension
at the same time as your wireless devices.
Connect your device to the extender's ethernet port using an ethernet cable.
What's happening
Extender running normally
Extender turned off
Ethernet connection established
No ethernet connection, or device switched off
Extender not configured to connect to hub/router
1
Go to step
Extender connecting to hub/router
If scrolling for more than 1 min, check your hub/router is
switched on and try moving your extender closer to it
WPS connection successful (goes off after 30 seconds)
connection error
No WPS session in progress