Advertisement
1
Plug in your extender
near your router
IMPORTANT: to ensure you have a good signal while setting things up, plug your
extender near your router/hub.
Plug the extender into a power socket near your broadband wireless router
1
(e.g. in the same room). Make sure the power socket's switched on.
Check the extender On/Off button on the top is switched on. Wait 20 seconds for
2
the extender to boot up. The Power light will be steady green and the Too close and
Too far red lights will be flashing together.
2
Wireless connection
to router
Connection to your router is very easy if it supports WPS; most recent routers do
(e.g. BT Home Hub 3 or 4, or any router that has a WPS button). However, if your
router doesn't support WPS, go to the section 'Connect to router without WPS'.
Press the WPS button on your router.
1
2
Press the WPS button on the extender (for 1 second) within 2 minutes.
Wait until the WPS light stops flashing. The extender is now configured with
3
your hub/router, and you're ready to find its optimum location.
1
Note: the WPS button is only used to connect to the router
and can't be used to connect devices.
2
2
3
WPS
WPS
Ethernet
Ethernet
Power
Power
Too close
Good range
Too far
Too close
Dual-Band Wi-Fi Extender
Good range
Too far
Dual-Band Wi-Fi Extender
1
WPS
WPS
Ethernet
Ethernet
Power
Power
Too close
Good range
Too far
Too close
Dual-Band Wi-Fi Extender
Good range
Too far
Please
open
out
Dual-Band Wi-Fi Extender
Advertisement
