SOYO SY-6VCA User Manual page 54

Hardware Installation
This is because the recorder and microphone in the Windows are not
enabled. Please go to sound properties and enable them.
Lock up (freeze)
When I boot up my system, everything works fine. It sees my CPU and
memory, detects my hard drive, floppy drive and CD-ROM but locks
up at "Verify DMI pool data... ", and it won't go any further. What
should I do?
Please clear the CMOS via JP5 then choose 'load setup default' in the bios
and save the bios and exit. Next, unplug all other add-on cards except the
video card and floppy drive controller, and see if it can boot from floppy.
Then put back the peripherals one by one to identify which one causes the
lockup. If you are running a Cyrix CPU, make sure the 'linear burst
function' is enabled in the bios.
I can not get my board to run properly.
Please make sure you have the latest bios and driver from the SOYO web
site at: http://www.soyo.com
Note on Over-clocking Capability
The SY-6VCA provides over-clocking capability. Due to the over-
clocking setting your system may fail to boot up or hang during run time.
Please perform the following steps to recover your system from the
abnormal situation :
1. Turn off system power (If you use an ATX power supply, and
depending on your system, you may have to press the power button
for more than 4 seconds to shut down the system.)
2. Set the JP8 and JP9 to short if you use a FSB 66MHz CPU
3. Press and hold down the <Insert> key while turning on the system
power. Keep holding down the <Insert> key until you see the message
of the CPU type and frequency shown on the screen.
50
SY-6VCA