Precaution; Specific Service Instructions - Kenwood NX-840H Service Manual

This service manual does not describe PRECAUTION.
2.1 SYSTEM SET-UP
Merchandise received
Choose the type of transceiver
Transceiver programming
KES-3
External speaker
2.2 REALIGNMENT
2.2.1 Modes
User mode
Data programming mode
PC mode
PC test mode
Clone mode
Mode
User mode For normal use.
PC mode Used for communication between the
transceiver and PC (IBM compatible).
PC programming Used to read and write frequency data
mode and other features to and from the
transceiver.
PC test mode Used to check the transceiver using the
PC.
This feature is included in the FPU.
PC tuning mode Used to tune the transceiver using the
PC.
Clone mode Used to transfer programming data
from one transceiver to another.
1-4 (No.RA011<Rev.001>)
SECTION 1

PRECAUTION

SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

KCT-60
Connection cable
(Option)
KCT-18
Ignition sense cable
Delivery
PC tuning mode
Function
RF power
Frequency range (MHz)
450~520
450~520
450~520
A personal computer, programming interface (KPG-46A/46U),
and FPU (programming software) are required for programming.
(Option)
KCT-36
Extension cable
(Option)
(Option)
KES-5
External speaker
2.2.2 How to Enter Each Mode
Mode
User mode
PC mode
Clone mode
Type
25W NX-840 M
45W NX-840H K
NX-840H(U) K
45W
(Option)
Function
Power ON
Received commands from PC
[ ] + Power ON (Two seconds)