Table of Contents
Advertisement
n
o
" "
' "
~
o'
"
I I>
~
:l"
~
."
C
"
~
o'
"
'"
""C
iii
-<
c:r
' "
n
",.
::;l
o
l:
c:r
iii
II>
:l"
o
~
:;'
«l
(j)
' "
::I
:;'
«l
~
:l"
' "
- i
3'
~
(j)
~
l:
"
(j)
"
' "
n
::;;
n'
~
0'
"
I I>
Do not wipe with a circular
motion.
CV
Load the two batteries properly
as indicated by the marks in the
battery compartment.
Gently wipe the disc from the
inside towards the outside.
~
About the Remote Control Unit
ENGLISH
Whl['lI-
Do not use record spray, antistatic agents, or benzene, thinner or other
solvents,
• If there are fingerprints or dirt on discs, wipe them off before using
the disc. Fingerprints and dirt can impair sound quality and cause
interruptions in playback.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
CD
Slide the rear lid in the
direction of the arrow and
remove it.
@ Put the rear cover back on.
whlr'lI-
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
o
"OOTr 00: 00" is displayed if a disc that cannot be played is loaded,
o
"OOTr 00: 00" is displayed if the disc is loaded upside-down or if no
disc is loaded.
o
Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
o
Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
o
Do not use discs on which the sticky part of cellophane tape or labels
is exposed or on which there are traces of where labels have been
removed. Such discs can get caught inside the player and damage
it.
• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from dust.
scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of time
2. Dusty or humid places
3. Places exposed to heat from heating appliances, etc.
o
Do not get fingerprints, oil or dirt on discs.
o
Take special care not to scratch discs when removing them from
their cases.
o
Do not bend or heat discs.
• Do not enlarge the hole at the center.
• Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly from a
cold place (outdoors for example) to a warm place, but do not try to
dry them off using a hairdryer, etc.
•
Do not touch the signal surface.
~
o
Place 8 cm discs in the inner tray guide without using an adapter.
WU')IW
o
Discs with special shapes (heart-shaped discs, octagonal discs, etc.)
cannot be played. Do not attempt to play them, as doing so can
damage the product.
o
Some discs and some recording
formats may not be playable.
~
>£)
o
Non-finalized
discs
cannot
be
played.
_
_
*
What is finalization?
-.;:.;:-
-::=
Finalization is the process that
makes recorded CD-R/CD-RW discs playable on compatible
players.
o
Set the disc with the labeled side facing up.
o
Make sure the disc tray is fully open when inserting the disc.
o
Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1), 8
cm discs in the inner tray guide (Figure 2).
Figure 1
I
,..Figure 2
3
Do not wipe with a circular
motion.
@
Load the two batteries properly
as indicated by the marks in the
battery compartment.
Gently wipe the disc from the
inside towards the outside.
About the Remote Control Unit
'Cleaning Discs
ENGLISH
• If there are fingerprints or dirt on discs, wipe them off before using
the disc. Fingerprints and dirt can impair sound quality and cause
interruptions in playback.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
@
Put the rear cover back on.
CD
Slide the rear lid in the
direction of the arrow and
remove it.
.~[.u.
Do not use record spray, antistatic agents, or benzene, thinner or other
solvents.
I@(,ii.
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
• Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
• Do not use discs on which the sticky part of cellophane tape or labels
is exposed or on which there are traces of where labels have been
removed. Such discs can get caught inside the player and damage
it.
• "OOTr 00: 00" is displayed if a disc that cannot be played is loaded.
• "OOTr 00: 00" is displayed if the disc is loaded upside-down or if no
disc is loaded.
• Do not get fingerprints, oil or dirt on discs.
• Take special care not to scratch discs when removing them from
their cases.
• Do not bend or heat discs.
• Do not enlarge the hole at the center.
• Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly from a
cold place (outdoors for example) to a warm place, but do not try to
dry them off using a hairdryer, etc.
• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from dust,
scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of time
2. Dusty or humid places
3. Places exposed to heat from heating appliances, etc.
l-
Cautions on Handling-
•
Do not touch the signal surface.
• Discs with special shapes (heart-shaped discs, octagonal discs, etc.)
cannot be played. Do not attempt to play them, as doing so can
damage the product.
• Some discs and some recording
formats may not be playable.
~
•
~I~~:~nalized
discs
cannot
be
~
__:::_
*
What is finalization?
~
---
Finalization is the process that
makes recorded CD-R/CD-RW discs playable on compatible
players.
• Set the disc with the labeled side facing up.
• Make sure the disc tray is fully open when inserting the disc.
• Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1). 8
cm discs in the inner tray guide (Figure 2).
Figure 1
Figure 2
• Place 8 cm discs in the inner tray guide without using an adapter.
I
HolCliDi]lIiW~.·
3
Hide quick links:
Advertisement
Table of Contents
