Connecting To A Macintosh Computer - Kodak DC5000 User Manual

Connecting to a Macintosh Computer

Either a serial cable for a Macintosh computer or adapter plug for use with the
RS-232 serial cable is provided so that you can connect your camera through a
serial port on a Macintosh computer.
Menu
Capture
Review
Setup
1
Set the Mode dial to Connect.
2
Connect the serial port adapter plug into the 9-
pin end of the serial cable.
3
Plug the adapter end of the serial cable into an
available serial port on the back of the
computer.
If your camera came with a serial cable for a
Macintosh computer instead of the serial
adapter plug, connect the end of the serial
cable labelled MAC into the available serial
port on the back of the computer.
Serial ports on Macintosh computers are
usually referred to as modem or
printer ports.
If the ports are not labeled, see your computer
User's Guide for a diagram that illustrates all
of the external ports.
4
Open the serial/USB port door on the side of
the camera.
5
Plug the other end of the serial cable into the
camera serial port.
6
Slide the POWER switch to the right to turn
on the camera.
If you get a message on your computer stating
that you are not connected, refer to the
Connect.PDF document installed with the
software, or the online help for
troubleshooting information.
7
63