Kodak DC5000 User Manual page 3

About the Camera's Weatherproof & Rugged Design
This camera is designed to be weatherproof and rugged. Special seals keep out
moisture for a sure, carefree performance in any weather. While you cannot use
the camera underwater, ideally it can safely be used:
in the rain
at pool-side or the beach
at a construction site or areas with excessive dirt or dust.
Important Camera Information
This camera is designed to be weatherproof, not waterproof. It is not designed to
be submerged in water, or have water poured over it. Please read the following
cautions before using it. Failure to follow the proper precautions may result in the
warranty being voided.
The camera doors and buttons have rubber seals that prevent water,
moisture, and dust from entering the camera. If the battery, memory card
door, and lens cover are not fastened or closed correctly, damage to the
camera can result. Also, while these doors are open, make sure that no
water or dust gets inside the camera or onto the weatherproof seals.
To ensure a proper seal, use a clean lint-free cloth to wipe off any dust,
sand, or hair that may accumulate on the rubber seals of the doors and lens
glass cover. Dust or sand on the seals may cause water leakage and may
damage the seals.
Do not press down on or remove any of the rubber seals.
When you find a damaged or deteriorated rubber seal, call the technical
support telephone number for your geographic area. Do not attempt to
change or fix the seal.
If the camera is not used for a period of time, it is normal to expect that
the button or switch may not move smoothly. Push the buttons and
switches several times to smooth out the motion.
Do not leave the camera exposed to rain or snow for extended periods
of time.
Use a clean lint-free cloth to wipe off any water or dirt after use, or before
opening any of the doors or covers on the camera.
Weatherproofing may be affected when the camera is exposed to sudden
changes in temperature. Allow the camera time to adjust to the
surrounding temperature before using it. This keeps moisture leaks or
condensation from occurring.