HP Compaq Compaq Presario V3000 Maintenance And Service Manual page 61

If it is necessary to replace any of the display assembly internal components, remove the following
9.
screw covers and screws. The display rubber screw covers are included in the Rubber Feet Kit, spare
part number 417096-001.
(1) Six rubber screw covers on the display bezel top edge and bottom edge corners
(2) Two rubber screw covers on the display bezel bottom edge
(3) Eight Phillips PM2.5×7.0 screws
NOTE:
must be installed in the bottom center screw holes.
Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
10.
bezel until the bezel disengages from the display enclosure.
Remove the display bezel (3). The display bezel is available using spare part number
11.
448613-001.
If it is necessary to replace the display inverter, remove the two black Phillips PM2.5×5.0 screws
12.
(1) that secure the inverter to the display enclosure.
Release the inverter (2) as far as the display panel cable and the backlight cable will allow.
13.
ENWW
There are two different sizes of display bezel rubber screw covers. The thicker covers (2)
Component replacement procedures 53