Table of Contents
Advertisement
Hardware Installation
SY-K7V DRAGON
Modem issues
I get an "I/O Conflict" message when I turn on my system and I can
not get my modem to work
What you need to do is to disable 'COM2' (or UART2 or serial port 2) in
the bios under integrated peripheral setup.
I have installed my modem drivers several times and I still cannot get
my modem to work. Why?
If you are sure that the modem driver has been installed correctly, then you
need to install the south bridge driver from the SOYO CD, this is because
Windows does not properly recognize relatively new chipsets.
Audio Issues
How can I disable the on-board Audio ?
Set the "Onboard 6Ch H/W Audio" option in the BIOS to disable this option
can be found under SOYO COMBO Feature.
In Device Manager, I keep getting yellow exclamation signs on my
sound port even though I have installed my sound driver several times
and I could not get my sound card to work. What is wrong?
It is likely that you did not have the correct driver installed. If you are sure
that the correct sound driver has been installed, then please install the 'VIA
4 in 1' driver for the motherboard.
The sound is working in my system, but when I play CD music from
the CD-ROM, I do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the sound
card is not connected or it is loose.
The sound and everything else works fine except that the recorder and
microphone do not work. What is wrong?
This is because the recorder and microphone in the Windows are not
enabled. Please go to sound properties and enable them.
49
Advertisement
Table of Contents
