Modem Issues; Audio Issues - SOYO SY-P4VSA User Manual

Hardware Installation SY-P4VSA
Hard disk, floppy drive, CD-ROM etc
When I boot up my new computer I got "floppy boot failure" and the
LED on the floppy stays on
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy
drive side (don't trust the "key lock" or "notch") and use the end-connector
of the cable (don't use middle one).

Modem issues

I get an "I/O Conflict" message when I turn on my system and I can
not get my modem to work.
What you need to do is to disable 'COM2' (or UART2 or serial port 2) in
the bios under integrated peripheral setup.
I have installed my modem drivers several times and I still cannot get
my modem to work. Why?
If you are sure that the modem driver has been installed correctly, then you
need to install the VIA 4 in 1 driver from the SOYO CD, this is because
Windows does not properly recognize relatively new chipsets.

Audio Issues

When I'm accessing my CD-ROM or in some application, I hear a
hissing sound, what could be the problem?
The audio cable is plugged on to the M/B the wrong way. Flip it around and
the problem should be solve.
Windows have detected the on-board audio, but I cannot get any
sound from my M/B, what could be the problem?
The audio cable is plugged on to the M/B the wrong way. Flip it around and
the problem should be solve.
How can I disable the on-board Audio ?
Set the "AC97 Audio" option in the BIOS to disable this option can be
found under SOYO COMBO Feature.
In Device Manager, I keep getting yellow exclamation signs on my
sound port even though I have installed my sound driver several times
47