Table of Contents
Advertisement
Installing Driver in Existing Windows 2000 System
WARNING: If you will be moving the boot drive containing the
existing Windows 2000 operating system to a mirrored RAID 1 array
on the FastTrak100-Lite, the FastTrak100-Lite driver MUST be loaded
to the hard drive while it is still attached to the regular IDE port. Do not attach this
drive or any other hard drive to the FastTrak100-Lite controller card before
completing this step.
During first boot in Window 2000, setup will show a "New Hardware Found"
dialog box. Under Windows 2000. the "PCI Mass Storage Controller" will be
displayed.
1.
In the dialog box, choose "Driver from disk provided by hardware
manufacturer" button.
2.
In the CD-Rom drive, insert the SOYO CD Driver.
3.
Type "D:\RAID\promise\Driver\Win2000" in the text box. Press "Enter".
Assuming the D: is your CD-Rom.
4.
Choose "Win2000 FastTrak100-Lite Controller" from the list that appears on
screen, then press the "Enter" key.
5.
The Windows 2000 Setup screen will appear again saying "Setup will load
support for the following mass storage devices – Win2000 Promise
FastTrak100-Lite controller". The FastTrak100-Lite driver will now be copied
on to the system and entered into the Windows 2000 driver database.
6.
When the "System Settings Change" dialog box appears, remove the
floppy diskette and click on "Yes" to restart the system. Windows 2000
will then restart for the driver installation to take effect.
135
Advertisement
Table of Contents
