Advertisement
1101 Secure Device Server Quick Start Guide
• To assign your serial device server a static IP address or to permanently enable
DHCP, select "System: IP" then "Network Interface" and check "DHCP" or
"Static" for configuration method.
Step 4: Configure serial and network devices.
• Select "Serial & Network: Serial Port," which will display the label, mode, and
protocol options currently set.
• To configure the serial port, click "Edit."
• Configure the Common Settings (baud rate, parity, data bits, stop bits, and flow
control) to match those of the serial device being controlled.
• By default, the LES1101A-R2 is configured in RS-232 mode. RS-232, RS-422, and
RS-485 are software-selectable. Simply press the button to Reset the unit back
to factory default (RS-232 mode).
• By default, the serial port is in console server mode. Refer to the user manual for
configuring other modes (terminal server, SDT, serial bridging).
• In Console Server Settings, select the protocols (Telnet, SSH, TCP, RFC2217,
unauthenticated Telnet) that are to be used for the data connection to the
device server and the serial port.
Page 4
Serial & Network: Serial Port screen.
724-746-5500 | blackbox.com
Advertisement
