Changing The Lamp - Dell 1609WX User Manual

Changing the Lamp

The following message appears on the screen when your projector lamp is
approaching end of life and requires to be changed:
Lamp is approaching the end of its useful life in full power operation.
Replacement suggested! www.dell.com/lamps
CAUTION:
Safety Instructions as described on page 6.
To replace the lamp:
Turn off the projector and disconnect the Power cable.
1
CAUTION:
the lamp until the projector has been allowed to cool down for at least 30
minutes.
Let the projector cool for at least 30 minutes.
2
Loosen the two screws that secure the lamp cover, and remove the cover.
3
CAUTION:
Projector lamps are very fragile and may shatter if touched.
CAUTION:
and dispose or recycle according to state, local, or federal law. For more
information see - www.dell.com/hg.
Loosen the two screws that secure the lamp.
4
Pull the lamp up by its metal handle.
5
Downloaded From projector-manual.com DELL Manuals
Before you begin any of the procedures in this section, follow the
The lamp becomes very hot when in use. Do not attempt to replace
Do not touch the projector lamp or the lamp glass at any time.
If the lamp shatters, remove all broken pieces from the projector
Troubleshooting Your Projector 41