Jet GH-1440ZX Operating Instructions Manual page 18

15. Compound Rest Traverse Handle (J,
Figure 13): Located on the end of the
compound slide.
counterclockwise to position.
16. Tool Post Clamping Lever (K, Figure 13):
Located on top of the tool post. Rotate
counterclockwise to loosen and clockwise to
tighten.
17. Tailstock Quill Clamping Lever (A, Figure
14): Located on the tailstock. Rotate
clockwise to lock the
counterclockwise to unlock.
18. Tailstock Clamping Lever (B, Figure 14):
Lift up to lock. Push down to unlock. If the
tailstock has a heavy load, tighten the
hexagon head at right side of the tailstock
for auxiliary locking.
19. Tailstock Quill Traverse Handwheel (C,
Figure 14): Rotate clockwise to advance the
quill and counterclockwise to retract it.
20. Tailstock Off-Set Adjustment (D, Figure
14): Two hex socket cap screws located on
the tailstock base are used to off-set the
tailstock for cutting tapers. Loosening one
screw while tightening the other will off-set
the tailstock. Do not clamp the tailstock lock
handle when adjusting.
21. Foot Brake (A, Figure 15): The connecting
rod mechanism is in the bed stand. The
braking device is in the pulley of the
headstock. Press the pedal to stop all lathe
functions. (Caution: Lathe still has power.)
22. Micro Carriage Stop (B, Figure 15): can be
used during manual feed operation. The dial
can be turned for fine tuning the position of
the stop. The micro carriage stop can be
moved along the bed by loosening the two
socket head cap screws underneath the
stop.
23. Bed Cover (C, Figure 15): can be easily
removed to clean out the stand.
Rotate clockwise or
sleeve. Rotate
Figure 13 (repeated)
Figure 14
Figure 15
18