General Wiring Instructions ..................................10 Control and Harness Diagram ................................11-14 Trobleshooting ......................................15 Warranty ........................................16 Spreader View Model # SP-100 ................................... 17 Hopper Assembly Parts Breakdown Model # SP-100 ..................................18-19 Gate Assembly Parts Breakdown Model # SP-100 ..................................20-21 Drive Assembly Parts Breakdown Model # SP-100 ..................................
RELIABILITY: High impact linear low density polyethelyne hopper. State-of-the-art electronic dual variable speed control, custom engineered powder coated frame, maximum torque 12-volt motor coupled to a custom engineered transmission; found only on SnowEx products. VERSATILITY: Multi-use capabilities allows spreading of a variety of materials for snow and ice control.
Introduction This manual has been designed for your help. It will assist you and instruct you on the proper set-up, installation and use of this spreader. Refer to the table of contents for an outline of this manual. We require that you read and understand the contents of this manual completely (especially all safety information) before attempting any procedure contained herein.
For your safety warning and information decals have been placed on this product to remind the operator of safety precautions . If anything happens to mark or destroy the decals, please request new ones from SnowEx. Never exceed the Gross Vehicle Weight Rating of vehicle. Failure to do so may limit a vehicles handling characteristics.
Operating the Spreader Model # SP-100 SPREADER LOADING WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for materials. Material Weight Per Cubic Ft. Rock Salt 80-90 lbs. Sand/Salt Mix 95-120 lbs.
Spreader Maintenance Model # SP-100 • WARNING – When servicing is necessary, perform it in a protected area Do not use power tools in rain or snow because of danger of electrical shock or injury. Keep area well lighted. Use proper tools. Keep the area of service clean to help avoid accidents.
It is not recommended to attach to fuel or brake lines for obvious reasons. Do not route close to exhaust system or engine, even though Snowex uses high temperature wiring, it still could melt under extreme heat and short the spreader electrical system, as well as the vehicle electrical system.
Control and Harness Diagram Model # SP-100 Part No. Description IMPORTANT: Do Not modify harness length. Any modifications D6474 Spreader Control | Utility will void warranty. T15028 Vehicle Harness | 189” Special Notes: T15083 Switch Assembly | DPDT 1) All external connections must have dielectric grease.
Page 14
Harness Diagram Model # SP-100 D6474 Controller Gate Switch On/Off Spreader Power Spinner Speed On/Off On/Off T15083 Switch Assembly Switch Circuts are Left - On Middle - None Right - On Load View Black Key Way Key Way Key Way on this End...
Neither Snowex, nor any company a liated with it, makes any warranties, representations for promise as to the performance or quality other than what is herein contained. The liability of Snowex to the purchaser for damages arising out of the manufacture, sale, delivery, use or resale of this spreader shall be limited to and shall not exceed the costs of repair or replacement of defective parts.
Need help?
Do you have a question about the SP-100 and is the answer not in the manual?
Questions and answers