Technical Data / Heater Identification Information (Hin) - Pentair MASTERTEMP 200 HD Installation And User Manual

| Heater Identification Information
iii
Heater Identification Information (HIN)
To identify the heater, see the data rating plate on the inner front panel of the heater. There are two designators for
each heater, one is the Model Number and the other is the Heater Identification Number (HIN).
Heater Identification Number (HIN)
The following example simplifies the identification system:
1) MT : MasterTemp
2) Model Size : (200, 300 or 400) : Input rating (Gross BTU/hr)
3) Construction : (HD = Heavy Duty Model)
4) Fuel Type : (LP = Propane gas or N = Natural gas)
HEATER IDENTIFICATION NUMBER
ID DESIGNATOR FOR PENTAIR POOL AND SPA MASTERTEMP HEATERS
Example:
1 2 3 4
N
MT 300 HD
Heater Data Rating Plate
The heater data rating plate is located on the inner front panel of the heater. To access the data rating plate, unbolt and
remove the side door access panel as shown below.
Heater Data Rating Plate Location
Top Panel
Remove this Door
Access Panel to access
the DATA RATING PLATE
™
MASTERTEMP Pool and Spa Heater Installation and User's Guide
H. I. N.
N = NATURAL GAS
FUEL TYPE =
LP = PROPANE GAS
HD = HEAVY DUTY MODEL
MODEL SIZE = BTU/hr GROSS INPUT
200 (200 [ ), 300 (300 [ ) or 400 (400 [
BTU/hr BTU/hr
MT = MASTERTEMP
Door
Access
Panel
MASTERTEMP
DESIGN AND MANFACTURED BY PENTAIR WATER POOL AND SPA, INC.
MINIMUM CLEARANCE FROM COMBUSTIBLE
CONSTRUCTED 15 CM REAR, 15 CM TOP.
APPROVED FOR INDOOR AND OUTDOOR INSTALLATIONS ELECTRICAL COMPLIANCE: IN ACCORDANCE
WITH LOCAL ELECTRICAL CODES.
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE BRITISH STANDARD INSTALLATION
CODES, AND WITH THE REQUIREMENTS OF THE AUTHORITY HAVING JURISDICTION.
)
BTU/hr
™ POOL HEATER
THIS HEATER IS EQUIPPED TO BURN
Model
200 HD 300 HD
INPUT RATE Qn= 53 kW Qn =79 kW
OUTPUT Pn= kW Pn=
2000 m
ALTITUDE
DO NOT INSTALL THIS HEATER UNDER AN OVERHANG
LESS THAN 1 METER FROM THE TOP. THE AREA UNDER
THE OVERHANG MUST BE OPEN ON THREE (3) SIDES.
REFER TO THE OPERATING INSTRUCTIONS FOR
APPROVED WATER TREATMENT.
TYPE G23
GAS
400 HD
Qn= 100 kW
kW Pn= kW
2000 m 2000 m
P/N 475106 Rev. A 2/2014