Putting The Heater Into Service; Specifications - Pentair MASTERTEMP 200 HD Installation And User Manual

8 | Section 1. Installation

PUTTING THE HEATER INTO SERVICE

If the heater is installed below the level of the pool, or more than 0.6 meters (2 feet) above pool level, the pressure switch
setting should be adjusted. See "WATER PRESSURE SWITCH" in the "SAFETY CONTROLS Section"
the "CAUTION" under "BELOW POOL INSTALLATION Section"
Before putting the heater into service for the first time, follow the instructions under "BEFORE START-UP"
the front of this manual. Check for proper operation of the heater by following the steps under, see page 4 "OPERATION
INSTRUCTIONS."
Notice: Damage to equipment caused by improper installation or repair will void the warranty.

SPECIFICATIONS

These installation instructions are designed for use by qualified personnel only, trained especially for installation of this
type of heating equipment and related components. Some states require installation and repair by licensed personnel. If
this applies in your state, be sure your contractor bears the appropriate license. See
DIMENSIONS IN CENTIMETERS & INCHES
40.6 cm
(16")
EXHAUST SIDE
Figure 9.
™
MASTERTEMP Pool and Spa Heater Installation and User's Guide
71.5 cm
(28.15")
FRONT
ELECTRICAL
CONDUIT PORT
71.6 cm
(28.2")
57.7 cm
(22.7")
40.6 cm
(16.0")
(page 10).
Figure 9
58.5 cm
(23.02")
82.8 cm
(32.61")
TOP
PLUMBING SIDE
(page 5) and
(page 3) in
for Outdoor Installations.
53.3 cm
(21.0")
25.7 cm
(10.13")
14.2 cm
(5.6")
P/N 475106 Rev. A 2/2014