Electronics - EcoSmart GWL10US Service Supplement Manual

· LSD - Load Sensing Detection is used to continually sense the load and automatically adjust
the agitation profiles to suit the wash load. It is also used to determine when a maximum
capacity profile needs to be used. If additional garments are added during the cycle the washer
will adjust accordingly, increasing the amount of water and changing the wash profile. If the
machine is operating on high water level, regular cycle, with a very large heavy load, then the
Load Sensing Detection will activate the Maximum Capacity Profile.
· MCP - Maximum Capacity Profile is present in the regular cycle, high water level only. It is
clearly noticeable. The machine will stop agitating and restart with a perceivably different
profile. The agitation time will also increase by 1 minute. MCP usually occurs 1-3 minutes into
the wash and will, of cause, only occur if the machine is heavily loaded.

ELECTRONICS

The electronics for Series 10 Smart Drive are now air cooled instead of being water cooled as in
previous models. This has been made possible by changes to the stator winding which allows a
lower current through the electronics and the use of the latest low loss semiconductor-switching
device.
With the Series 10 Smart Drive you can no longer turn the machine on by using the cycle buttons,
you must press the Power button first.
The delay start is now 1, 3 or 9 hours; previous models were 1, 6 or 9 hours. This change was
introduced as a result of the last customer survey.
On the Delicate and Permanent Press cycles the medium spin speed can now be selected if required,
the default setting is still the slow spin. This was done to improve the customer's options, as slow
spin left the clothes too damp for some customers.
Electronic Modules are not inter-changeable between models. The different modules for the
different models can be identified by their color. Phase 3 modules are green, Series 8 modules are
yellow and the latest Series 10 modules are Grey.
It is important not to mix the different colored modules as they are not compatible with each other
and you will find that the washing machine will not work. It will automatically display a fault code
and beep if the modules have been mismatched.