EcoSmart GWL10US Service Supplement Manual page 26

59. (00111011) ID Out of Range Fault
When the pause or delay start is pressed to start the machine, the Display checked the physical ID
and found it was out of range.
Primary Source - Display Module.
Action - Replace Display Module.
60. (00111100) Motor Controller Memory Check Fault
On power up the Motor Controller Module has checked its memory against a known reference
and found differences.
Primary Source - Motor Controller Module.
Action - Replace Motor Controller Module.
61. (00111101) Brown Out During Motor Controller EEPROM Write Fault
The Motor Controller Module has been attempting to perform an internal EEPROM write. Prior
to writing the Motor Controller Module has tested the 15-volt supply and found that it is below
the safety level for writing EEPROM and has reported this to the Display Module.
62. (00111110) Pump Over-current Fault
The motor controller has detected excess current in the pump windings. Most likely caused by
water leaking onto pump.
Primary source - drain pump
Action - replace drain pump
Secondary source - motor controller module
Action - replace motor controller module
63. (00111111) Pump Communications Fault
The motor controller has detected a problem communicating with the pump microprocessor.
Primary source - motor controller module
Action - replace motor controller module
64. (01000000) Pressure transducer frequency out of range (<66kHz)
65. (01000001) Pressure transducer frequency out of range (>80kHz)
66. (01000010) Pressure transducer frequency out of range (>90kHz)
The motor controller has detected a problem with the pressure transducer
Primary source - Motor Controller
Action - Replace Motor Controller Module
81 - 95. (0101xxxx) See fault code 106
104. (01101000) See fault code 106
105. (01101001) See fault code 106