Re-Start Feature; Re-Cycle Feature; Hot Tub Flag - EcoSmart GWL10US Service Supplement Manual

3.5 RE-START FEATURE

WATER LEVEL DOWN button turns the RE-START feature on/off.
LOW WATER LEVEL LED ON = RE-START ON. (Factory setting).
LOW WATER LEVEL LED OFF = RE-START OFF.
1. If a fault occurs in the machine, the diagnostic system will detect it. However, instead of
displaying a fault code immediately, the machine will try to RE-START.
2. If the fault was only of a temporary nature, the machine will re-start.
3. If there is a continuous fault the machine will try to RE-START a number of times. This
process could take up to 8 minutes depending on the type of fault. After this, if the machine still
cannot restart, the fault code is displayed and the machine will beep continuously.
The machine leaves the factory with the RE-START feature turned on. When the machine is being
serviced it is more convenient to turn the RE-START feature OFF. This will allow any fault in the
system to show up immediately.
Whether the RE-START feature is on or off can be easily identified without going into the
DIAGNOSTIC MODE.
When the machine is first turned on -
(a) If none of the 5 green wash progress LED's are on, the RE-START feature is on.
(b) If the 5 green wash progress LED's are flashing, the RE-START feature is off.
NOTE - This feature is designed as a service aid only and should be left ON in the customer's
home. To return to normal operation, and to reset the RE-START feature to the factory setting,
switch the machine off at the wall or disconnect from the mains supply.

3.6 RE-CYCLE FEATURE

WATER LEVEL UP button turns the RE-CYCLE feature on/off.
MEDIUM WATER LEVEL LED ON = RE-CYCLE ON.
MEDIUM WATER LEVEL LED OFF = RE-CYCLE OFF. (Factory setting).
At the end of servicing, the machine may require an extended test where the machine can be left to
complete a number of wash cycles. By turning on the RE-CYCLE feature the machine will
continuously repeat the wash cycle until the RE-CYCLE feature is turned off.
Whether the RE-CYCLE feature is on or off can be easily identified without going into the
DIAGNOSTIC MODE.
When the machine is first turned on:
(a) If the 3 orange/red rinse and spin progress LED's are on, the re-cycle feature is off.
(b) If the 3 orange/red rinse and spin LED's flash, the re-cycle feature is on.
NOTE - This feature is designed as a service aid only and should be OFF in the customer's home.
To return to normal operation, and to return the re-cycle feature to the factory setting, switch the
machine off at the wall or disconnect from the mains supply.

3.7 HOT TUB FLAG

If the machine has been filled with hot water and has not had a cold rinse the electronics will not
allow the machine to spin up to its full speed of 1000 RPM. It will only allow the spin speed to
reach 700 RPM.
The WATER SAVER LED will be on when the DIAGNOSTIC MODE is selected if the spin
speed is restricted to 700 RPM. To clear this flag press the WASH OPTION button.